【產品名稱】柔性防水漿料(18kg)

特點; 滲透性強

耐水性好

耐候性好

綠色環保

【規格】9KG/桶、18KG/桶

【包裝形式】桶裝

【產品特點】1.無害,，施工簡便,、快速

2.柔韌性(能覆蓋細小裂痕)及粘結力強

3.很好的耐水性、耐腐蝕性

注：配合燕化粘結劑系列產品施工效果更佳

【適用范圍】室內外通用,，如廚房,、衛生間、陽臺,、地下室,、樓頂、養魚池,、浴池等

【用量計算】厚度0.5mm，2.5kg/㎡(涂抹兩遍的用量)

【施工要求】1.基礎要堅實無空鼓,、無開裂,、無孔洞

2.基面要平整，無污垢,、油漬,、浮塵、尖角,、凹凸不平處,、返砂、脫模劑等

3.基面轉角處應做成圓弧形

【施工方法】1.基面充分潤濕但無明水

2.先將液料倒入桶中,，再緩緩加入粉料(切記不得加水),，攪拌均勻(無粉料結團)

3.靜置10分鐘后進行二次攪拌3-5分鐘即可使用

4.沿水平方向均勻涂抹第一遍，涂抹厚度0.5mm(衛生間要向上延伸20-30cm)

5.待第一層表面干燥后(4-8小時),，沿垂直方向均勻涂抹第二遍(和第一遍形成交叉施工),，厚度0.5mm

【注意事項】轉角和薄弱處(開槽、管根,、墻角等),、水池應多遍涂抹，每遍厚度約0.5mm

保持期：12個月 執行標準：GB/T23445-2009 [Product Name] Flexible Waterproof Slurry

Features: Super penetration Good water resistance Good weather resistance Green and eco-friendly

[Specification] 9KG/ barrel, 18KG/ barrel

[Packing form] barrel packing

[Product Features] 1. Non-toxic and harmless, simple and rapid construction. 2. Flexibility (covering small cracks) and strong adhesion. 3. Excellent water resistance and corrosion resistance. Note: the construction effect is better with Tianle Qianjie adhesive series products. [Scope of Application] Indoor and outdoor use, such as kitchens, toilets, balconies, basements, roofs, fishponds, bathtubs, etc. [Dosage Calculation] Thickness: 0.5mm, 2.5kg/m2 (the amount of coating twice) [Construction Requirements] 1. The foundation shall be solid without hollowing, cracking and holes. 2. The base surface should be flat and free of dirt, oil stains, floating dust, sharp corners, uneven places, return sand, release agent, etc. 3. The corner of base plane should be made into arc shape. [Construction Method] 1. The base surface is fully moistened but there is no visible water. 2. First pour the liquid material into the barrel, then slowly add the powder never add water), and mix thoroughly (no powder agglomeration). 3. Let stand for 10 minutes and stir for 3-5 minutes for the second time. 4. Apply evenly for the first time along the horizontal direction, with the thickness of 0.5mm (the toilet shall extend upward for 20-30cm). 5. After the surface of the first layer is dried (4-8 hours), apply the second time (cross construction with the first layer) evenly along the vertical direction The thickness is 0.5mm. [Precautions] The corners and weak points (slotting, pipe roots, wall corners, etc.) and pool should be painted several times with the thickness of each time about 0.5mm. Retention period: 12 months Executive standard: GB/T23445-2009